If you bought a set of Painmaster Microcurrent patches and want to know how it works, you are likely to find the information here. Alternatively, please check our FAQs page, or contact us. You can also download the Instruction Manual below.
How to use Painmaster MCT patches
Getting started with Painmaster MCT patches
For the best results, it’s recommended to wear the patches for as long as possible during the initial treatment, up to 72 hours, as long as they remain comfortable. After this phase, wearing the patches for at least 4-6 hours at a time (including overnight or during daily activities) can help maintain effectiveness.
Before applying the patches, ensure your skin is clean and free of excess hair for better adhesion. Keep in mind that Painmaster is not an instant pain relief solution. It works gradually over time, supporting long-term pain management rather than providing a quick fix.
Painmaster MCT patch placement
It is very important to place the patches in the right part of your body. Please make sure that you do not place them directly over the area where you feel the pain. Ideally, you should place it on either side or one above and one below it. Also, please make sure that you attach the patches next to the source of the pain (sometimes pain can irradiate away from the source of pain and onto other parts of the body).
Do not use Painmaster patches on your head, front of neck or genital area.
How to remove and reapply Painmaster MCT patches
Gently remove each pad by pulling from the tab at the top. Store them on the original plastic backing provided with the patches. Make sure to disconnect the wire before storing.
To reapply the patches, peel them off gently from the plastic film where they have been stored. If you find that they are not sticking to the skin as well as they were initially, it may help applying a drop of warm water over them. Always make sure that your skin is clean and free of oil, sweat and hair.
Skin reactions
In rare cases, skin irritation may develop at the electrode site. This tends to happen after prolonged use of Painmaster MCT patches. If irritation occurs, peel off the patches and take a break from treatment. This skin reaction, known as erythema, usually clears up within a few hours to a few days.
Some people who have sensitive skin may experience mild irritation when using the patches. If symptoms persist, discontinue use and consult your doctor.
Swimming, showering, bathing...
Please remove the patches before you get into water. Although you can safely spalsh water on the patches themselves, you must not put them under water. The electronic device is not waterproof, and it will get damaged if it goes under water. If the gel side of the patches accidentally gets wet, turn it upside down and let it air-dry. Make sure that the patches are completely dry before reattaching the wire and battery.
Applying Painmaster MCT Patches
Back Pain
You can place the patches vertically or horizontally on either side of the painful area. If needed, up to three sets can be used at the same time. For severe lower back pain, try positioning two sets vertically on either side of the spine for maximum relief.
Unlike medications or other pain relief methods, Micro-Current Therapy works with the body’s natural healing process rather than simply blocking pain signals.
Neck Pain
Neck pain is usually centered in the middle but may shift slightly to the left or right. To target the pain effectively, identify the most uncomfortable area and place one patch on each side.
For severe neck pain, wear the patches continuously for 2-3 days, including while sleeping; just make sure to remove them before showering or bathing.
Important: NEVER place patches on the front of the neck.
Elbow Pain
For elbow pain relief, place the patches on the outer side of the elbow (as shown on the left). If the pain is more on the inner side, adjust the patch placement to target the affected area.
You can position the patches vertically or horizontally on either side of the pain for the best results.
When wearing Painmaster while sleeping, consider wearing a shirt, pyjamas or a light bandage over the patches to help protect them from damage.
Nerve Pain
Nerve pain can affect various parts of the body, but it is most commonly felt in the lower back, buttocks and legs.
Finding the best patch placement may require some trial and error. In many cases, applying Painmaster to the lower spine is most effective, as nerve pain (such as sciatic pain) often originates from this area.
Reminder: You won’t feel any electrical sensations while wearing the patches.
Joint Pain
Place the patches vertically or horizontally on either side of the pain’s center for optimal relief.
If needed, you can use up to three sets at once. The length of treatment depends on how long you’ve had joint pain, so some trial and error may be necessary to see if Painmaster works for you.
The patches can be worn 24/7, including while sleeping, but consider protecting them from excessive rubbing to extend their lifespan.
Important Guidelines:
- Do not place patches on the front/side of the neck (especially over the carotid sinus).
- Avoid positioning patches in a way that allows current to pass through the head (transcerebrally).
- Electronic monitoring devices (e.g., ECG monitors and alarms) may not function properly while using this device.
- Remove the device during any high-frequency medical procedures.
Do NOT use Painmaster if:
- You have a cardiac pacemaker
- You are using an insulin pump
- The user is under 12 years old
- You are pregnant
- Applying it directly over or near transdermal drug patches
- Placing it on open wounds, broken or inflamed skin, infections, recent scars or areas with vascular issues such as thrombosis or varicose veins
Painmaster Patch Usage Guidelines:
- For external use only
- Do not apply over open wounds
- Keep out of reach of children
- If a rash appears, discontinue use for a day
- For single-person use only
- Do not use more than three sets of patches at the same time
Patch Disposal: Painmaster patches contain no hazardous materials and can be disposed of with regular waste. Do not recharge, disassemble or burn the battery.